On a new roof we build in proper slope, drains and crickets so water never sits. Most flat roof problems come from poor drainage designed in at the start.
Two heat-welded plies create a single waterproof sheet with no glued seams to dry out, a big advantage over cheaper single-ply options.
Planning a rooftop deck? We install a walkable cap sheet and detail thresholds and railings during construction, when it is easiest to do right.
Contemporary Okanagan homes often use flat and low-slope roof sections. Torch-on gives you the clean look without the leak risk.
We check the roof deck, slope and fastening before anything goes down, and correct problems while the roof is open.
A base sheet, then a granulated SBS cap sheet heat-welded on top, for two full layers of protection.
We install drains and build crickets so water flows off the roof instead of ponding in low spots.
Custom drip edges, wall flashings and parapet caps finish the roof and protect every edge from water and wind.
We review your plans or site, confirm slope and drainage, and give you a detailed written quote and schedule.
On new construction we work around framers, decks and windows so flashings are integrated, not added later.
Our crew torches the base and cap sheets with controlled heat and overlapping seams for a continuous waterproof membrane.
We inspect every seam and flashing with you, clean up the site and register your manufacturer warranty.
We work with general contractors and homeowners on new builds and additions, and we show up when the schedule says we will.
Proper slope, drainage and flashings are built in to meet code and manufacturer requirements from the start.
We follow fire-watch procedures on every job and keep torching away from combustible framing and finishes.
Installing a complete manufacturer system means you get material and workmanship coverage on your new roof.
If your project mixes flat and sloped roofs, we install torch-on, metal and shingle sections so everything ties together properly.
Modern homes with flat or low-slope roof sections, roof decks and parapets.
Detached garages, carports and workshops that need a durable, low-maintenance flat roof.
Bump-outs, sunrooms and second-storey additions that tie into an existing roof.
Retail, office and light industrial buildings with large flat roof areas.
